Omnicleaner

Main Features

Omnicleaner is formulated to effectively clean and degrease oils, fats, general dirt and atmospheric dust, pollution and also hydrocarbon deposits from vehicle exhausts.

Omnicleaner has a multitude of uses and will clean most types of heavily soiled surfaces, floors, walls, worktops, bathrooms, toilets etc.

It is particularly suitable for the pre-treatment of masonry surfaces both walls and floor prior to painting or coating.

It is ideal for use in cleaning machines and is used extensively by building management companies, hotels, casinos, car park operators and private homes.

The waste water is biodegradable and is permitted to be flushed down normal storm water systems without subsequent treatment and without damaging the environment.

Technical Benefits

Omnicleaner can be diluted up to maximum of 1:50 parts with water but normal dilutions are in the range of 1:9.

Dilution percentages depend on a number of parameters, including the type and amount of dirt to be removed, the application method and temperature of the solution.

Omnicleaner is suitable for all methods of application, from brush to low and high pressure water cleaning equipment. It is ideal for use in cleaning machines.

It does not affect the performance of oil and water separators.

After any application of Omnicleaner and the cleaning process completed, the cleaned surface should be rinsed with fresh water.

How to use?

Directions for Use

1. For extremely dirty surfaces:
   brush or vacuum the surface and remove loose dirt and dust. Dampen the surface with clean water using mop or roller.
   Apply a thin film of Omnicleaner diluted 1:4 (Omniclean:Water) using a paint brush or roller. Leave on the surface for 5-10 minutes. Scrub surface with scrubbing brush or 3M pad soaked in water to lift the dirt. Then fully rinse surface with clean water, remove the water using mop or wet vacuum.

   The effect of the cleaner will be increased if hot water is used for the washing process.

2. For less dirty surfaces:
   Mix Omnicleaner with clean water at a ratio of approx. 1:9. Apply a film of material onto area to be cleaned using mop, roller or brush.
   Scrub surface with scrubbing brush or mop to lift dirt. Rinse the surface with clear water and remove by mop or wet vacuum.

   The effect of the cleaner will be increased if hot water is used for the washing process.

3. For standard household cleaning:
   Mix Omnicleaner with clean water at a ratio of approx. 1:20. Apply a film of material onto area to be cleaned using mop, swissbrawatch roller or brush.
   Scrub surface with scrubbing brush or mop to lift dirt. Rinse the surface with clear water and remove by mop or wet vacuum.

   The effect of the cleaner will be increased if hot water is used for the washing process.